Flame Control 60-60A is a 25-Minute Thermal Barrier for Spray Polyurethane Foam Insulation.  A water-based, low VOC, intumescent latex paint, 60-60A has been tested to NFPA 286 test standards and has been approved for use on spray foam insulation.  Flame Control 60-60A is suitable for use in inhabited (occupied) spaces where spray foam insulation must be coated with a thermal barrier per the IBC.

60-60A should be applied in a single coat, and does not require a primer.  These features make 60-60A the easiest to use, fastest to apply thermal barrier available on the market.  

Performance Information:

⭐ Provides a ULC and NFPA test method qualifying thermal barrier on spray polyurethane foam installations - See Fire Hazard Classification Section.
⭐ Dries by water evaporation to a tough, hard, velvety flat finish.
⭐ Does not leach (lose fire retardancy) on exposure to high humidity.
⭐ Meets all present VOC and environmental/ecological regulations

Recommended Uses:

For application to spray polyurethane foam surfaces in occupied spaces where spray foam insulation must be separated from the interior of the building per IBC Section 2603.4 approval, and on exterior surfaces when protected as above.