Penofin LOG ON wood stain has 99% UV protection, the highest rating of any transparent finish. LOG ON wood stain has the finest mildew protection found anywhere. LOG ON wood stain is a semi-transparent wood finish that penetrates deeper than any other transparent wood stain. It really nourishes and protects the wood. You'll use LOG ON wood stain in high altitude environments where sun, wind, rain, and snow are toughest on wood. LOG ON wood stain is perfect for log homes and timber frame properties that experience fierce weather conditions! From the Appalachians and the Ozarks, to Whistler and the Rockies, from the Tetons to the Wasatch, and to the Blue Ridge Mountains and beyond, LOG ON wood stain! 

Penofin is not a high solid, lay-on-the-surface type common log and timber frame finish. No! Penetrating Penofin wood stain is so incredible; the fibers are nourished and stabilized deep within the wood. Penofin's LOG ON wood stain is available in three transparent tones that will enhance any log or timber frame structure.

Features

• Wood stain for timber frame and log homes
• Non-Film forming
• Sustainably harvested Brazilian Rosewood Oil
• Preserves & protects
• Extends life of wood
• Excellent mildew protection
• Dry to touch in 4 hours
• Serviceable in 12 hours
• Fully cured in 4-7 days

Application

Stir this product thoroughly before and during application. Apply at temperatures above 45°. Penofin is stable under freeze/ thaw conditions. For optimum performance bring the stain to room temperature before application. Do not apply if the wood is hot to the touch. Using a brush, stain pad, or plastic pump sprayer apply a liberal coat to the wood. Protect, tarp, or mask off any adjacent areas you do not wish to stain. Penofin is a penetrating finish and will penetrate any porous surface. Allow Penofin 20 -30 minutes to penetrate the wood. This step is important as it allows the finish to coat the individual fibers of the wood, protecting your investment from the inside out.  After 20-30 minutes back brush the surface thoroughly with clean dry brushes to remove any excess finish.  If using the 2 coat (550 VOC formula), wait a minimum of 4 hours before applying a second light coat of Penofin. Again after 20-30 minutes wipe the surface thoroughly to remove any excess finish. Penofin is a penetrating finish and is not a surface coating. Failure to wipe will allow the finish to dry on the surface of the wood and will result in a tacky finish. Soak any wiping cloths in a bucket of water to avoid the possibility of spontaneous combustion which can occur with any oil-based product.